To attach the lanyard to the Rockscan W100, proceed as follows:


  1. Detach the loop on the clip from the lanyard by pressing the two latches on the side inwards and then pulling the loop off. This will make the following steps easier.
  2. Use something very thin and flexible, such as sewing thread, thin wire, or similar. It must fit easily through the recess at the corner of the Rockscan W100.
  3. Pass the thin tool through the loop.
  4. Guide the tool with the loop hooked into it through the mounting opening on the Rockscan W100.
  5. Pull the loop through the opening. Then remove the tool.
  6. Wrap the loop around the retaining clip.
  7. Pull the clip to secure the loop.
  8. Now reattach the clip to the lanyard.