The software is configured via the "Camera Tool". The software allows the configuration of the following functions and parameters:





  • Change the device password
  • Changing the Device ID
  • Change User ID / Police ID
  • WLAN SSID and password
  • Device time
  • Video resolution and video quality
  • Post- and Pre-Recording Mode
  • Audio settings for pre-recording mode
  • Infrared sensors
  • Loudspeaker volume
  • Photo resolution
  • Activated WLAN and GPS function at startup
  • Length of the video file
  • Notification of admission
  • Motion detection
  • RSA Encryption
  • Front LED
  • Loop recording
  • Stealth mode
  • Behavior after device activation
  • Enabling the camera as a mass storage medium
  • Preparation for firmware update







 Hint


The default password of the Impakt BC200 bodycam is 123456. You need this password to unlock the bodycam in the Camera Tool.




 Hint


Pre-recording is limited due to memory constraints. Use a maximum resolution of 1296P for H.265, and a maximum resolution of H.264 for H.264. Higher settings can lead to undesired malfunctions.




 Hint


WLAN streaming and pre-recording cannot be combined and can lead to undesired behavior.




 Hint


Do not use the 1296P configuration with a video length of 30 minutes. This could cause problems.




 Hint


In any case, check whether all settings have been correctly adopted before you use the device again in operation. Due to the limited processor power, memory settings that have already been set can also be lost when parameters are changed. If necessary, these must then be set again. This is not a malfunction, but due to the extremely low power consumption.