Switch on product

Press the function key for about 2 seconds until the power LED lights up green. Successful startup of the device is confirmed by a beep and vibration. There is no notification when Impakt BC200 is in stealth mode.

Switching off the product

Press the function key for about 2 seconds. The successful switching off of the device is confirmed by a signal tone and vibration. There is no notification when Impakt BC200 is in Stealth mode.

Video recording

To record a video, press the record button located on the front of the device (under the camera lens). The unit will beep and vibrate. A red power indicator on the top of the device lights up and stays red during recording. Press the record button twice to stop recording with two beeps and vibration. Video recording cannot be stopped if the total recording time is less than 5 seconds. (The device will not give feedback if you stop recording within 5 seconds). In the activated pre-recording mode, tap once to start pre-recording first. The recording LED starts to blink. Press the record button again to start the actual recording.

Taking a photo

To take a photo, press the photo button on the right side (button A). The bodycam will emit a beep and vibration. During the recording, the power LED (1) and the record button (8) light up red.

Checking the battery charge level

Impakt BC200 comes with four battery LED indicators (D). Briefly press the photo and function key (key A+B). The device emits a beep and a vibration. The LEDs indicate the battery status as follows:

All four LEDs are lit: Battery status between 75% - 100%.

Three LEDs are lit: Battery status between 50% - 75%

Two LEDs are on: Battery status between 25% - 50%

One LED lit: Battery status lower than 25%